Previously, only wood was used for wall cladding, but at the present time it has become popular to use waste from other work with wood, This can be bark, sawdust, etc. etc.
Cladding walls with wooden panels is a simple matter, you can not even turn to specialists for help, but do the work on your own. But such work is difficult, if not impossible, to do alone, here you need an assistant. In addition, you need to have a high-quality set of tools. In such work, care is important - measurements must be accurate, errors are unacceptable. Of course, as in any work, certain instructions will not be superfluous.
As mentioned above, measurements must be done accurately and correctly. It is advisable to do them twice. This applies mainly to those cases where the installed panels are exclusive and expensive. Measurements must be taken on everyone.The length and height of walls, doors, windows should be measured. In the process of work, you can stumble upon some details, such as mounting boxes. In this case, there is no need to worry.
Wooden panels must be ventilated. Do not neglect this procedure - its importance is no less than all other work. It is necessary to ventilate in order to prevent further occurrence of various defects on the panels. For ventilation, it is necessary to put the panels separately each, along the wall in a vertical position and stand for two days. If it is not possible to ventilate the panels using this method, and you had to stack them on the floor, then they should have gaps through which air could freely pass.
It is not advisable to nail wooden panels to the wall. To ensure successful wall cladding, the surface on which the panels are to be installed must be smooth. Therefore, it is necessary to ensure smoothness before proceeding with the wall sheathing with wood.
The next step is to install rails. The slats are essential to provide a secure base for wood paneling. Their location depends on the location of the panels themselves. They can be horizontal and vertical. Thin planks, as well as roofing shingles, are chosen as rails. This is necessary so that the slats are as even as possible.
When installing the first wooden panel, proceed with extreme caution. After all, the quality of the installation of the first panel will depend on how the rest will become. The first panel is a kind of sample. The starting point of the installation should be the first corner that the eye falls on when entering the room.
In the event that the instructions for installing purchased wood panels contain a recommendation to nail them, then the size of the nails must be indicated in the same instructions.
According to materials:
Did the article help you?