Even with the purchase of high-quality equipment and a well-made installation, it is impossible to insure that the washing machine will not jump during the spin cycle. You can, of course, not react to this, but the result will be a decrease in the life of the unit. The cause of the trouble may be technical problems or the machine was installed in the wrong place.
If the unit is new
If the machine jumps during the spin cycle, which was installed not so long ago, then the reasons can be easily eliminated. First of all, you should check if there are bolts for fixing the drum; if they are, you will need to remove the elements. Often they are simply forgotten to be removed, which often causes a breakdown of the machine.The bolts are located at the back of the unit, they are easy to unscrew.
Important! You don't need to discard these items. If you need to transport the unit, they can be useful.
Another reason may be incorrect installation. It is better to carry out the process using a level, if the machine staggers even in the off position, then jumping will be observed even in the washing mode. It is worth refraining from installing the unit on slippery floors.
Misuse
The washing machine may start jumping due to improper loading. You should know some rules that should be followed in order to avoid vibration:
- Do not load the machine above the indicated limit. If it is noticeable that the drum is more than half full, then this is already considered to be an excess of the required volume.
- It is unacceptable to lay things in one lump, this will lead to an imbalance of the laundry. Before placing them in the machine, it is necessary to unfold the products.
- If one thing is to be cleansed, one should be prepared for a strong vibration. It is better to pause and restart the linen.
Leveling the machine
First of all, you should stock up on a level, the length of which will be about a meter. It is better not to use smaller ones, since the accuracy will be less. You will also need to prepare a pair of open-end wrenches that will match the size of the nuts on the legs of the unit. Using the level, you will need to check the horizontalness of the site, then check the two adjacent sides along. If everything is in order, install the machine. In the presence of distortions, it is required to place stands on low places so that the horizontality is observed in the necessary directions.
Coasters can be made using any flat and hard material. Where the machine will come into contact with the floor covering, it is necessary to stick a thin sheet of rubber. This is necessary so that the unit is not damaged when bouncing. If you correctly install and use the washing machine, then there will be no problems with jumping during the spin cycle. It should be remembered that due to such a nuisance, you can damage the unit, which means you can be left without your faithful assistant.
Did the article help you?