The household station is used in the usual family household and household, as well as in the country. This is a necessary equipment in order to get water in the house, if only a water well has been drilled on the site. The pump creates the pressure needed to produce water. The water pump is used to create pressure for various kinds of watering (beds, flowers, lawn, etc.). Also, with the help of a pump, you can easily pump water out of the well without any effort. A wide range of quality pumps from the best manufacturers you can choose from
What are the types of water pumps for water intake?
- external (in simple words they call it - superficial);
- submersible (in other words - deep);
- injector.
What is the difference between these three types? Outdoor pumps allow water to be pumped from a shallower reservoir or above ground water tank to the location where the water is needed. A submersible pump pumps water from a deeper position. More often, such a pump is used in a well or lowered into the well itself. There is also a centrifugal pump.
Another type of water accessories is a water station. This is an integral technique when a well is punched in the area, but there is no central pipeline.
How to connect a water station in the house?
In order to bring water into the house, of course, you first need to drill a water well. But this is not at all necessary when a central water pipe is connected to the site or there is a well in which there is enough water for consumption.
The installation itself is not very difficult for people who have an idea in this type of work. Also, the manufacturer in the kit encloses the installation instructions for this type.
It is worth considering the fact that it is possible to install a water station in the house when the well is not very far away, as well as the station itself with high power, which allows you to draw water inside.
The pump can only be installed directly in the water source itself.
What is the algorithm for connecting a water pumping station?
First you need to choose a place where the station will be installed. Next, one end with a water pipe must be connected to a storage tank. Next, the water from the tank must be connected to the inlet to the pump. And to the hole on the "exit" you need to connect a pipe that leads to the house. Next is the electrical installation. Next, the pressure inside the pump is adjusted.In general, connecting and setting up the pump is a fairly simple job.
The pumping station can be purchased both in finished form and completely assembled by yourself, the main thing is to understand the spare parts in order to put everything right and not sort it out several times.
Did the article help you?